时间：2019-12-07
●润滑Lubrication
◆轴承润滑Bearing lubrication
▲脂润滑Grease lubrication
渣浆泵所用轴承在泵生产厂家已经按规定上了润滑脂，所以在低转速，低温（相对于120℃）的工作条件下，本泵在使用过程中无需上润滑脂。在高负荷高温（相对于120℃）工作条件下的泵，轴承必须定期上润滑脂，挖泥泵，以保证其使用寿命。对必须定期上润滑脂的泵，必须选用和轴承原用润滑脂相容的品种，否则润滑效果差，影响轴承寿命。加注工具：标准手工加注枪。加注周期及加注量：对昼夜使用的泵，每周加注一次，每次每个轴承注五枪，对一昼夜工作8小时的泵，每三周加注一次，每次每个轴承注五枪，对昼夜使用的泵，也可以每月加注一次，每次每个轴承注二十枪。
The pump bearings on the grease pump manufacturers have been required at low speed, low temperature(relative to the operating conditions of 120℃), the pump during use without the need on the grease. The high temperature in the high load (relative to the pump operating conditions of 120℃), the bearings must be regularly on the grease to ensure that its service life. Grease pump must be on a regular basis, must be selected and bearing the original varieties compatible with grease or lubrication affect the bearing life. Filling tool: standard manual filling gun. Filling cycle and raise the amount of day and night use of the pump a week filling time, five shots each each bearing Note, the pump on a work night and day 8 hours every three weeks filling time, every time each bearing note five shots on the day and night to use the pump, can also be a monthly filling time, each bearing Note 20 gun.
▲润滑油：每天检查一次，必要时按要求加注润滑油。
Oil lubrication: check once every day and pour lubricating oil according to requirement when necessary.
